HP Hewlett Packard Welder ML 150 G3 User Manual

Connecting hp StorageWorks SAS tape drives to  
hp ProLiant ML150 G3 servers using the supplied cable  
The option of this server that provides support for SAS hard drives uses an HP 8 Internal Port SAS with RAID  
controller. The most cost-effective way to connect the SAS tape drive to the server is to use the special cable  
supplied with the tape drive.  
This installation requires you to remove one of the existing SAS cables and replace it with the cable supplied  
with the tape drive. This does not affect your existing hard disk drive configuration. (If this cabling solution is  
not acceptable, you must purchase and install a new, supported SAS HBA.)  
1. Locate the cable to be removed  
These servers support up to 6 hard disk drives. You need to replace the cable that connects to hard disk drives  
5 and 6.  
2. Identify the SAS port on the SAS controller  
Trace the other end of the cable back to the SAS controller card to identify the SAS port to which it is  
connected.  
The poster supplied with your tape drive provides detailed instructions about replacing the cable and  
installing the tape drive.  
 

Graco GPS Receiver NVI 200 User Manual
Graco Stroller 6111 User Manual
Haier Washer Dryer HWM50 10 User Manual
Hans Grohe Plumbing Product 320XX User Manual
Harbor Freight Tools Automobile Parts 96500 User Manual
Hasbro Portable Stereo System GES 3+ User Manual
Honeywell Barcode Reader EGPWS User Manual
Husqvarna Trimmer 325HDA55 x series 325HE3 325HE3 x series 325HE4 x series User Manual
IMC Networks Radio SP50 User Manual
Impex Home Gym PM 4500 User Manual